Wheel camber is applied to the rear wheels of a wheelchair. It can be described as an angling that brings the top of the wheels closer to each other.
Athletes who wished to improve wheelchair-handling characteristics and stability first introduced camber into wheelchairs. It can be described as an angling that brings the top of the wheels closer to each other. Athletes who wished to improve wheelchair-handling characteristics and stability first introduced camber into wheelchairs.
The amount of camber introduced into the wheels is measured in degrees. The higher the number the more camber or angling there is. Some wheelchairs have methods of adjusting the camber, while others do not. Camber adjustment is most often accomplished by inserting a different camber bar that alters the angle or by adjusting the axle plate for increased camber. Wheelchairs with fixed camber do not allow for altering the angle. In these cases the camber angle may be specified when the wheelchair is ordered (except in the case of low end wheelchairs).
As camber is increased, the width of the wheelchair across the bottom increases. This adds lateral stability to the system by increasing the wheelchairs footprint. If to much camber is added there may be a problem getting through doorways. The amount of wheelchair wheel camber required for daily use is not commonly the same as that which is required for wheelchair sports.
Pros
- The wider footprint adds lateral stability to the wheelchair.
- Redirects forces to soften the ride.
- Places the push rims in a more ergonomic position for pushing. It is more natural to push down and outward.
- Protects the hands when pushing in tight areas since the bottom of the wheels will make contact first with walls and doorframes.
- Less strain on shoulders since the plane of the wheel is closer to that of the shoulder joint.
- Makes turning quicker.
- Gives the wheelchair a sportier look.
Cons
- Wheelchair will be wider.
- May add cost to the chair.
- Excessive camber may cause the wheels to rub against the armrest side panels or against the user.
- Diminished traction and uneven tire wear on a conventional tire.
Conventional tread placement is centered on the tire. A cambered tire rides on the inside edges of the tire. Some manufacturers make tires with offset treads to compensate for cambering. - Adds complexity to the wheelchair
